Using Your Machine; Connection And Prior Installation; Using The Machine - Brandt TH1700EV Manuel D'instruction

3)

USING YOUR MACHINE

a)

Connection and Prior Installation

 Put the tea maker on its base. Unroll the lead and plug the machine in.

A beep sounds and the screen shows "F".
 At this stage the real temperature of the water is shown on the display screen. None of
the indicator lights are on.
b)

Using the Machine

 Place the machine on a dry, flat, stable surface.
 Remove the machine from the base. Remove the lid and the tea basket from inside the
machine. Then fill the tea maker with water.
 The quantity of water is visible through the body of the machine. It must never be lower
than the "2 cup" mark or higher than the 1.7 l mark. Caution, if the tea maker is overfull
water may be ejected when boiling.
Note: The quantity of water must never be lower than the tea basket when it is in the
machine. If this is the case the tea will not infuse properly.
 Place the tea in the basket and put this into the tea maker in the place provided for it.
 Close the lid and put the machine on its base.
Never fill the tea maker through the spout.
Never open the lid when the water is boiling.
Avoid contact with the steam from the spout.
 Select your heating temperature by pressing the "+" or "-" temperature keys.
 Once the temperature has been selected press the On/Off button. A red LED comes on
below the pictogram indicating boiling. The machine starts.
 You can see the rise in water temperature in real time on the display screen. Also when
the machine is in operation blue neon lights appear inside the tea maker.
 Once the temperature is reached a beep sounds and the red LED under the pictogram
indicating boiling goes out.
 It is now possible to serve your tea or keep it warm by clicking twice on the On/Off
button. A red LED then comes on under the button indicating that the tea is being kept
warm.
To use the machine as a kettle just remove the tea basket. The operating principle is exactly
the same.
19