Publicité
Les langues disponibles
Les langues disponibles
2. Are all the locking handles secured?
3. Is the fence parallel to the saw blade?
4. Is the protective cap working properly?
5. Are you wearing safety goggles?
6. Is the saw blade not rubbing against
anything?
It is absolutely necessary to take these
points into consideration before you
start work!
Lengthwise sawing
•
Secure the fence to the correct measuring
position and remove the cut-off guide from
the bench carriage.
•
Turn the saw blade approximately 2 mm
higher than the total thickness of the wood
to be sawn.
•
Press the wood lightly towards the bench
and let it glide against the cut-off fence.
Remain at least 3 cm. from the front of
the saw blade before you switch on
the engine. The side of the wood
which is against the fence must be
completely straight. Keep your hands
at least 10 cm away from the saw
track to be followed.
•
Switch on the engine and wait until the saw
blade has reached the maximum number
of revolutions before you start sawing.
•
While you press the wood against the
bench and the fence, you can carefully
push the wood through the saw blade
without forcing it.
•
Never pull the workpiece backwards.
If necessary, switch off the engine
first without altering the position of the
workpiece.
Lengthwise sawing with a(vertical) mitre
This method is practically the same, except that
the saw blade is placed at the angle required.
With this type of method the fence
may only be along the righthand side
of the sawblade.
Lengthwise sawing of narrow workpieces
Assume that this process is extremely
dangerous.
Ferm
Take all the necessary safety measures and
continually push the workpiece through (until
behind the saw blade) using a synthetic aid
instead of by hand.
Crosswise sawing
•
Remove the fence and apply the cross-cut
fence in the righthand carriage.
•
Adjust the height of the saw blade (see
lengthwise sawing).
•
Press the workpiece against the cross-cut
fence and keep at least 2,5 cm distance
from the front of the saw blade.
•
Switch on the engine and wait until the
maximum number of revolutions has been
reached.
•
Press the workpiece against the fence
and the bench. Carefully push the wood
through the saw blade. Continue until
behind the saw blade. Then switch off the
engine and keep this position until the saw
blade has stopped completely before you
remove the wood.
•
Never pull the wood back. If necessary,
switch the engine off and keep the
position until the saw blade has stopped
completely.
Crosswise sawing with a vertical mitre
This method is practically the same, except that
the saw blade is placed in the angle required.
Only place the cross-cut fence on the
righthand side of the saw blade. Never
saw too small pieces of wood. Never
use your hands to carry out difficult
operations.
Crosswise sawing with a horizontal mitre
With this method the cross-cut fence must
be secured at the angle required. Keep the
workpiece pressed firmly against the cross-cut
fence and the bench before you start cutting off.
5. MAINTENANCE
Make sure that the machine is not live
when carrying out maintenance work
on the motor.
The machines have been designed to operate
over a long period of time with a minimum of
maintenance. Continuous satisfactory operation
depends upon proper machine care and regular
cleaning.
GB
9
Publicité
