Publicité
Les langues disponibles
Les langues disponibles
a
Charging the battery
The supplied LiPo Battery will be charged with the provided LiPo Balancer.
Connect the power adaptor to a 220V outlet and the balancer, the balancers LED will light up in red.
Connect the LiPo battery to the matching port on the balancer. Check the polarity and make sure that
the plug is connected firmly. The plug provides a lead. The green LED lights up.
.
Charging takes around 30-45 minutes. When the battery is fully charged, the green LED will shut off.
Please only use the original battery, as other batteries may have another polarity!
.
Inserting and connecting the battery
When the battery is fully charged, you can insert it inside the battery case on the bottom of the zoopa
Q model.
Switch on the controller. The Power LED on the remote control starts to blink. Move the gas stick (left)
up and down. The LED lights up continuously. Repeat this process one more time.
Connect the female cable (port) of the zoopa Q model with the battery cable (plug).
Pay attention on the polarity of the battery when you connect it to the model !
Place the zoopa Q650 on a plain surface. The models LED starts to flash fast and then passes over to
a slow blinking, which shows the successful binding to the remote control.
www.acme-online.de
ACME the game company
Publicité
