ANSMANN Racing Intelligent Digital Balance Charger xBase 2.0 Deluxe Mode D'emploi page 5

Masquer les pouces Voir aussi pour Intelligent Digital Balance Charger xBase 2.0 Deluxe:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

When NiMH or NiCd battery is on the cyclic process of charge/
discharge, it can often become warm. The program insert a time
delay to occur after each charge and discharge process to allow the
battery adequate time to cool down before being subjected to the
next process (see the screen
) the value ranges from 1 to 60
A5
minutes. If you are not sure,you can set it over 10 minutes.
The charger will automatically supply the trickle function to achieve
the full charge with out overheating the battery after fast charge has
been teminated. You can alter the trickle value when the charger
shows you the screen
.
A6
When you start a charge process, the integral safety timer automati-
cally starts running at the same time. This is programmed to prevent
overcharge the battery if it proves to be faulty, or if the termination
circuit cannot detect the battery full
can be on or off, and you can set the maximum safety time, the
value ranges from 10 to 720 min. As the same principle,there is a
maximum-capacity-limited function. See
10 to 20000 mAh.
Types
Item
Standard voltage (V/cell)
Max. charge voltage cut off level (V/cell)
Allowable fast current
Min. discharge voltage cut off level (V/cell)
Chart A
Digital Balance Charger xBase 2.0 Deluxe
. Shows you this program
A7
, the value ranges from
A8
Lipo
3.70
4.20
<1C
>3.00
At the screen
you can set the audible sounds to be on or off by
A9
this program.
When you use the car battery to supply power for charger, screen
shows you this program monitors the voltage of input DC battery.
If the voltage drops below the value you set the operation forcibly
terminated to protect the input battery.
You can adjust the brightness of LCD screen at the charger(see
Please refer the information below
(chart A), and select the correct
parameter for each battery, or it will
cause a serious result!
Lilo
LiF e
NiMH
3.60
3.30
1.20
4.10
3.60
1.60
<1C
<4C
<2C
3.00
2.00
1.00
A10
).
A11
NiCD
Pb
1.20
2.00
1.60
2.45
<2C
<0.4C
0.85
1.75
5

Publicité

Table des Matières
loading

Table des Matières