FALMEC Time Mode D'emploi page 21

1) - CREATE A NEW CODE
The procedure is to be carried out on the radio control.
• Press LIGHT and TIMER
flashing.
• Press DOWN on the radio control: saving is confirmed by three
brief flashes of the display. The new code cancels and replaces the
previous default code.
Reconnect the hood to the electrical power supply, making
sure that the lights and motor are off.
2) - ASSOCIATING THE RADIO CONTROL WITH THE HOOD
USING THE ELECTRONIC PUSHBUTTON PANEL
press TIMER ( ) on the hood pushbutton panel for 2 seconds:
the red LED lights up.
press any key on the radio control within 10 seconds.
RESTORING DEFAULT CODE
the procedure is to be carried out if the hood is disposed of, sold or
transferred.
Disconnect the power to the hood before starting the pro-
cedure.
• Press UP and DOWN simultaneously on the radio control for
more than 5 seconds: reset is confirmed by three brief flashes of the
display.
• Reconnect the hood to the electrical power supply.
• Proceed with associating the hood and the radio control, as de-
scribed in point 2.
MAINTENANCE
Before cleaning or carrying out maintenance operations,
disconnect the equipment by removing the plug or
switching off the main switch.
Do not use detergents containing abrasive, acidic or corrosive
substances or abrasive cloths.
Regular maintenance guarantees proper operation and performance
over time.
Special attention is to be paid to the metal anti-grease filters and active
carbon filters: frequent cleaning of the filters and their supports ensures
that no flammable grease is accumulated.
CLEANING OF EXTERNAL SURFACES
You are advised to clean the external surfaces of the hood at least
once every 15 days to prevent oily substances and grease from stick-
ing to them. To clean the brushed stainless steel hood, the Manufac-
turer recommends using ''Magic Steel'' wipes. Alternatively, it can be
cleaned using a damp cloth, slightly moistened with neutral, liquid
detergent or denatured alcohol. Finish off cleaning by rinsing well and
drying with soft cloths.
simultaneously until the display starts
Do not use too much water next to the push button con-
trol panel and lighting devices in order to prevent humid-
ity from reaching electronic parts.
The glass panels can only be cleaned with specific, non-corrosive or
non-abrasive detergents using a soft cloth.
The Manufacturer declines all responsibility for failure to comply with
these instructions.
CLEANING OF INTERNAL SURFACES
It is forbidden to clean electrical parts, or parts related to
the motor inside the hood, with liquids or solvents.
For the internal metal parts, see the previous paragraph.
METAL ANTI-GREASE FILTERS
It is advised to frequently was the metal filters (at least once a month)
leaving them to soak in boiling water and washing up liquid for 1 hour,
taking care not to bend them.
Do not use corrosive, acid or alkaline detergents.
Rinse them well and wait for them to be completely dry before reas-
sembling them. Washing in a dishwasher is permitted, however, it may
cause the filter material to darken: to reduce the possibility of this prob-
lem from happening, use low-temperature washes (55°C max.).
To extract and insert the metal anti-grease filters see the assembly in-
structions.
ACTIVE CARBON FILTERS
These filters retain the odours in the air that passes through them. The
purified air is recirculated into the environment.
The active carbon filters must be replaced on average every 3-4 months
under normal conditions of use.
LIGHTING
The range hood is equipped with high efficiency, low consumption LED
spotlights with extremely long duration under normal use conditions.
Should the LED spotlight need to be replaced, proceed as shown in
the figure.
1
2
21
3
12V