AEG 9000 LONGFRESH Manuel De L'utilisateur page 25

11.3 Positioning
This appliance is not intended to be used
as a built-in appliance.
This appliance should be installed in a
dry, well ventilated indoor position.
This appliance is intended to be used at
ambient temperature ranging from 10°C
to 43°C.
If, due to different installation, proper
ventilation requirements are not
respected, the appliance will function
correctly but energy consumption might
increase slightly.
The correct operation of
the appliance can only be
guaranteed within the specified
temperature range.
If you have any doubts regarding
where to install the appliance,
please turn to the vendor, to
our customer service or to the
nearest Authorised Service
Centre.
It must be possible to disconnect
the appliance from the mains
power supply. The plug must
therefore be easily accessible
after installation.
CAUTION
If you position the appliance
against the wall, use back
spacers provided or keep the
minimum distance indicated in
the installation instructions.
CAUTION
If you install the appliance next
to a wall, refer to the installation
instructions to understand the
minimum distance between
the wall and the side of the
appliance where door hinges
are to provide enough space to
open the door when the internal
equipment is removed (e.g.
when cleaning).
11.4 Door opening
The refrigerator should be positioned
to allow easy access to a counter when
removing food. For best use of refrigerator
drawers and freezer baskets, the
refrigerator should be in a position
where both can be fully opened.
11.5 Cabinet Leveling &
Refrigerator Door
Alignment (if necessary)
Guidelines for final positioning
of refrigerator:
• All four corners of the cabinet must
rest firmly on the floor.
• The front should be slightly elevated
to ensure that doors close and seal
properly.
• Doors should align with each other
and be level.
Most of these conditions can be met by
raising or lowering the adjustable front
rollers.
To level the cabinet using the front rollers:
1. Slightly open freezer drawer.
2. Lower anti-tip legs until they are both
touching the floor. Once on the floor,
use a pair of pliers to adjust.
To raise unit: turn leg clockwise.
To lower unit: turn leg
counterclockwise.
3. Ensure both doors are bind-free with
their seals touching the cabinet on all
four sides and that cabinet is stable.
ENGLISH 25