Operation; Salt Refi Ll; Automatic Displayed Messages - CPED INITIAL Notice Originale

For hardness tuning at high fl ow rates, largely open a tap downstream of the softener and measure
again the hardness.
Use this time the knob (27) to tune the hardness:
- Unscrew to increase it
- Screw to decrease it
NOTE: it is under the user's responsibility to defi ne the residual hardness compatible with the
equipment installed downstream of the softener.
Salt refi ll
The device uses regenerating salt, dedicated to softening. The salt tank bottom shall always be co-
vered by solid salt over its whole surface. Please refer to the Scope of Delivey sheet in order to know
the salt storage capacity of your softener, and to the chapter TECHNICAL FEATURES to know its
salt consumption per regeneration.

Automatic displayed messages

The displays shows:
Œ
an upper information line
•
a lower information line
Ž
a bargraph with 10 segments, showing the
remaining autonomy of the softener before the
next regeneration, by steps of 10%. The graph
in this example shows 70% remaining autonomy
For each operation step of the device, the displayed messages are as follows:
SERV
Alternate with
12:30
REMPL
375
SAUM
180
REGE 1
00:45
REGE 2
18:35
REGE 3
02:15
CHECK Alternate with
STD-BY
Alternate with
12:30
Notice technique ADOUCISSEUR A27-A6X - Manual SOFTENER A27-A6X code P0011144 - Rev 0 - 29/02/2016

OPERATION

968
The device is in service: it delivers softened water.
Its treatment autonomy before regeneration is here 968 liters.
12:30
Water is being poured into the salt tank (see chapter ADVANCED
SETTING), it will end in 375 seconds.
The brine is under preparation in the salt tank for the next regene-
ration; this step will end here in 180 minutes.
The softener is going through its fi rst active regeneration step, which
will end here in 0 minutes and 45 seconds.
The softener is going through its second active regeneration step,
which will end here in 18 minutes and 35 seconds.
The softener is going through its third active regeneration step, which
will end here in 02 minutes and 15 seconds.
The softener detects a lack of salt and advises to check the salt
SALT
level in the salt tank.
The regeneration function is OFF (see Stand-By mode next page).
968
The softener delivers soft water as long as its autonomy allows it
12:30
(here: autonomy of 968 liters).
Ž Œ
•
29