Baumer CombiPress PFMH/N Manuel De Mise En Service page 6

CombiPress™ PFMH/N
Fully welded pressure transmitter with touch screen
5.3 PFMH mounting
DANGER
Risk of injury from hazardous medium
Only use weld-in sleeves or adapters from Baumer.
f
„
Wear protective equipment for hazardous media (e.g. acids, alkaline solutions).
f
„
Do not seal the process connections with Teflon tape or elastomer.
f
„
Empty vessel and pipe before mounting.
f
„
1
2
Check leak-tightness of the sleeve.
f „
Check tightness of the cable glands or M12 plug.
f „
Ensure that the housing cover is fastened properly.
f „
Example of mounting with weld-in sleeve ZPW2-621
6 / 48
Pressure measurement
1
1
1
2
Operating Instructions
9 Hole for mounting the sensor is easily accessible
Mount weld-in sleeve or adapter as follows:
f
„
3-A mark or arrow points upwards
„ „
Leakage hole points downwards
„ „
Hygienically and internally flush
„ „
Grind welding to Ra ≤ 0.8 μm.
f „
Remove protection cap from diaphragm.
f „
Push the sealing ring on (1).
f „
Mount the sensor and tighten closure clamp (2).
f „
1 ZPW2-621 (BHC 3A DN38)
2 Leakage hole
www.baumer.com