Configuration - Baumer CombiPress PFMH/N Manuel De Mise En Service

7.2 Explosive gas atmospheres zone 2
The PFMH and PFMN can be used in explosion hazardous areas of zone 2 without using Zener barriers.
Approval for PFMx-xx.xxxx.xxxxx.xxxxx.x3xx: Ex nA II T5
All PFMN/H with protection type nA
Comply with the following temperatures and
f „
connection values.
8.

Configuration

8.1 Configuration via touch screen
Programming CombiView, type DFON
Tap on the display screen and hold until the menu button appears.
f
„
Press menu to start the configuration.
f
„
Examples
Configure damping value.
f „
Menu PFMx menu
Configure pressure unit.
f
„
PFMx menu
Menu
Further available settings:
f „
Input and display outputs
„ „
Relays
„ „
Warning and error indication
„ „
Screen layout
„ „
8.2 Zero point
Relative pressure
Set zero pressure equal to atmospheric pressure
f „
or level in the selcted tank.
Absolute pressure
Set zero point lower than 1 mbar absolute.
f
„
Revert to factory setting
Select factory settings with FlexProgrammer.
f „
For optimal results, adjust zero point after mounting.
www.baumer.com
Output con g. Damping
Unit setup Pressure unit
Operating Instructions
Pressure measurement
CombiPress™ PFMH/N
Fully welded pressure transmitter with touch screen
ATEX II 3G Ex nA II T5
Supply range
Temperature class
with display
„ „
without display
„ „
Damping value
Select from list
Backlight intensity
„ „
Color
„ „
Language
„ „
Zero point adjustment
9 Pressure transmitter and installation area have
the same temperature
9 Zero point pressure set
Press zero button and hold until LED starts to
f „
flash fast.
FlexProgrammer or HART configurator can be
used alternatively.
Un: 35 V DC max.
In: 100 mA max.
T1 ... T5:
–30 < Tamb < 65 °C
–40 < Tamb < 85 °C
11 / 48