Table Des Matières; Safety - Baumer CombiPress PFMH/N Manuel De Mise En Service

Table of contents
1. Safety .......................................................... 3
2. Construction and function ........................... 4
3. Symbols ...................................................... 4
4. Transport and storage ................................. 4
5. Mounting .................................................... 5
6. Electrical connection ................................... 7
7. Electrical connection in explosion hazardous
areas ........................................................ 10
1.

Safety

Intended use
The sensor measures pressure of liquids and
gases within the range of -40 ... 200 °C.
The sensor must only be used for media against
which the housing material and sensor tip are
resistant.
Staff qualification
Only use staff who are trained for the activities
described. This applies in particular to assembly,
installation, configuration and troubleshooting.
Make sure that the staff have read and understood
these instructions.
Electrical connection and EMC
All electrical wirings must comply with local
standards and connections must be made
according to the connection diagrams.
www.baumer.com
Pressure measurement
CombiPress™ PFMH/N
Fully welded pressure transmitter with touch screen
8. Configuration ..............................................11
9. Operation ...................................................12
10. Troubleshooting .........................................13
11. Cleaning, maintenance and repair..............13
12. Disposal .....................................................13
13. Accessories ................................................13
14. Technical data ............................................14
15. Configuration overview ...............................15
Technical condition
Only use sensor in perfect technical condition.
Only use Baumer accessories.
Baumer will accept no liability for other
manufacturers' accessories.
Operation
The power supply and environmental conditions
must comply with the specifications of the device.
Before switching the device on and off, possible
effects on other equipment and the process run
must be checked.
Risk of burns from hot media
During operation the sensor housing may warm
up to over 50 ºC. When working with hot media
provide protection against burns.
Operating Instructions 3 / 48