HQ Power HQLE10032 Mode D'emploi page 5

4. Operation
4.1 Indoor Use
1. Place the projector onto the
stand base [1] and turn
clockwise until locked.
2. Connect the 2-pin plug of the
power cord to the adaptor
inlet insuring proper polarity.
To avoid water getting in,
make sure to turn the plug
cap clockwise until secure.
3. Connect the power adapter
to the mains.
4. Adjust the angle of the
projector as desired [2].
4.2 Outdoor Use
1. Place the projector onto the
stand base [1] and turn
clockwise until locked.
2. Connect the 2-pin plug of the
power cord to the adaptor
inlet insuring proper polarity.
To avoid water getting in,
make sure to turn the plug
cap clockwise until secure.
3. Connect the power adapter
to the mains.
4. Adjust the angle of the
projector as desired [2].
V. 03 – 27/11/2017
HQLE10032
5 ©Velleman nv