Additional Functions - brennenstuhl CM L 4050 Mode D'emploi

048316 CO-Melder CM L 4050.qxp_048316 BA_CO-Melder CM L
CM L 4050
ALARM SIGNAL & LED- DISPLAY
Note:
I I I
Detector function
Normal operation
Alarm status
Empty battery –
Warning
Sensor error
Warning: End of the
sensor service life

4.4 Additional Functions

The CO-detector is provided with the following
additional user-friendly functions:
Alarm function:
This function is used to turn off the alarm for
5 minutes.
Press the "Test / Reset" button on the alarm.
If the CO-concentration reaches 200 ppm (parts
per million), the alarm will reactivate. The detector
returns to normal function automatically in
5 minutes.
Operating Instructions
means "peep, peep, peep"
Green Red
Energy display Alarm signal
Power Alarm
Blinks every 30 --
sec.
--
4 beeps +
blinker
-- --
-- --
blinks every 30 blinks
sec.
Beep
Red Alarm tone
Error signal
Fault
-- --
-- ■ ■ ■ ■ - 5s-
■ ■ ■ ■ - 5s-
■ ■ ■ ■ --
1 beep + blinking ■ - 30 sec.-
every 30 sec. ■ - 30 sec.-
■ --
2 beeps + blinks ■ ■ - 30 sec.-
every 30 sec. ■ ■ - 30 sec.-
■ ■ - 30 sec.-
-- ■ - 30 sec.-
■ - 30 sec.-
■ --
25