Clarion CM1624TB Mode D'emploi Et Manuel D'installation page 7

4. INSTALLATION
Surface Mount Installation
STEP 1:
Remove tower speakers and all the hardware
from the packaging.
STEP 2:
Using supplied M4 Allen wrench, loosen the
base clamp hex head shaft bolts on the left and
right side.
STEP 3:
Begin by pulling mount assembly out of base
clamp while feeding the cable through the mount
hole to create a gap between base and surface
mount parts.
STEP 4:
When adequate space is created, use the su-
pplied M5 Allen wrench to loosen and remove
the bolts connecting the surface mount and bar
mount pieces.
STEP 5:
Once the bolts are removed, pull the bar mount
and assembly completely off of the wire.
STEP 6:
Find a good location to run the wires that will not
impede movement of the tower speakers.
NOTE:
The tower speaker accommodates two different
types of speaker wire installation:
1. Going straight into a hole in the surface thus
the speaker wire will be routed through the cen-
ter hole of the rubber spacing insert. For this ins-
tallation type, please proceed to STEP 7.
2. Alongside the surface thus the speaker wire
will exit the rubber spacing insert through the
side notch. For this installation type, please pro-
ceed to STEP 8.
NOTE:
Blue Loctite is highly recommended when
installing the hex head bolts.
M4 Allen
Wrench
M5 Allen
Wrench
CM1624TB / CM1624TS
7