ZANKER ZKK 8416 K Notice D'utilisation page 22

Problem
It is too warm in the freezer
It is too cold inside the freez-
er
The appliance does not
work at all. The appliance
does not cool at all. Neither
cooling nor lighting works
Replacing the lamp
Caution! Disconnect the plug from the mains
socket.
1. Remove the
screw from the
lamp cover.
2. Remove the lamp
cover (refer to the
illustration).
3. Replace the used
lamp with a new
22
Possible cause
Temperature Regulator may be set
incorrectly
The door does not close tightly or it
is not shut properly
Large quantities of food to be fro-
zen were put in at the same time
Food placed in the appliance was
too warm
Products to be frozen are placed
too closely to each other
Temperature Regulator may be set
incorrectly
The appliance may be switched off
Plug is not connected to the mains
socket properly
Power does not reach the appliance Try connecting another electrical de-
There is no voltage in the mains
socket (try to connect another appli-
ance into it)
Set a lower temperature
Check if the door closes well and the
gasket is undamaged and clean
Insert smaller quantities of food to be
frozen at any one time.
Allow food to cool to room tempera-
ture before storing.
Place the products in a way so that
cold air could circulate among them
Set a warmer temperature
Switch on the appliance
Connect the mains plug properly
vice to the power outlet
Call an electrician
lamp of the same
power and specifi-
cally designed for
household appli-
ances (the maxi-
mum power is
shown on the
lamp cover).
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door. Make sure that the light comes on.
Solution