Indirect Vertical Distance Using Two Points (Total Height); Indirect Vertical Distance Using Two Points (Partial Height) - RIDGID micro LM-400 Mode D'emploi

micro LM-400 Laser Distance Meter

Indirect Vertical Distance Using Two Points (Total Height)

Figure 14 – Indirect Vertical Distance Using Two Points (Total Height)
1. Press Angle/Stake Out Button (
the display. The distance to be measured will flash in the symbol.
2. Aim the laser at the first target 1 below the laser distance meter and press
ON/Measurement Button to take the measurement.
3. Aim the laser at the second target 2 above the laser distance meter and press
ON/Measurement Button to take the measurement.
4. The display shows; the lower measured diagonal distance L1 in the second
line, the upper measured diagonal distance L2 in the third line, and the cal-
culated vertical A distance in the fourth line.
Indirect Vertical Distance Using Two Points
(Partial Height)
Figure 15 – Indirect Vertical Distance Using Two Points (Partial Height)
1. Press Angle/Stake Out Button (
the display. The distance to be measured will flash in the symbol.
2. Aim the laser at the first target 1 and press ON/Measurement Button to take
the measurement.
3. Aim the laser at the second target 2 and press ON/Measurement Button to
take the measurement.
4. The display shows; the measured diagonal distance L1 in the second line, the
measured diagonal distance L2 in the third line, and the calculated vertical A
distance in the fourth line.
999-999-480.09_REV C
L2
2
1
L1
2
L2
1
L1
A
) four times, the symbol (
A
) five times, the symbol (
) will show in
) will show in
15