Service And Repair; Disposal; Battery Disposal - RIDGID micro LM-400 Mode D'emploi

micro LM-400 Laser Distance Meter

Service and Repair

Improper service or repair can make the RIDGID micro LM-400 Laser
Distance Meter unsafe to operate.
Service and repair of the micro LM-400 Laser Distance Meter must be per-
formed by a RIDGID Authorized Independent Service Center.
For information on your nearest RIDGID Authorized Independent Service Cen-
ter or any service or repair questions:
• Contact your local RIDGID distributor.
• Visit RIDGID.com to find your local RIDGID contact point.
• Contact Ridge Tool Technical Service Department at rtctechservices@emer-
son.com, or in the U.S. and Canada call (800) 519-3456.

Disposal

Parts of the RIDGID micro LM-400 Laser Distance Meter contain valuable mate-
rials and can be recycled. There are companies that specialize in recycling that
may be found locally. Dispose of the components in compliance with all applica-
ble regulations. Contact your local waste management authority for more infor-
mation.
For EC Countries: Do not dispose of elec trical equipment with house-
hold waste!
According to the European Guideline 2012/19/EU for Waste Electrical
and Electronic Equipment and its implemen tation into national legisla-
tion, electrical equipment that is no longer usable must be collected
separately and disposed of in an environmentally correct manner.

Battery Disposal

For EC countries: Defective or used batteries must be recycled according to the
guideline 2012/19/EU.
999-999-480.09_REV C
WARNING
17