Telcoma Automations FOX Notice D'instruction page 36

GB
ANTENNA
To improve reception and range of radio remote controls, installation of
theproper antenna is recommended.
For best results the antenna should be fixed as high as possible to fairly large
metal supports, such as gutters, railings, etc., But should not be sheltered by
them.
A cable with an impedance of 50 ohms (e.g.RG58) is recommended for
connecting the antenna and receiver. This cable should not exceed 10 metres
in length.
FINAL RECOMMENDATIONS
1. Always cut off the power supply before wiring up or changing
connections.
2. For outdoor installations, the receiver should be adequately protected
according to the real environmental conditions.
3. Requests for 24LC04 or 24LC16 storage should always be made with
"for FOX range receivers" clearly specified.
4. Whenever the range of a transmitter is reduced, replace the battery with
one that has identical characteristics.
**Failure to comply with the above instructions may jeopardise correct
operation of the equipment.
TELCOMA S.r.l. cannot be held liable for any malfunctioning and/or
damage or injury arising from failure to comply with the above
conditions.
In line with its continual product improvement policy, whether aesthetic or
functional, TELCOMA S.r.l. reserves the right to alter specifications without
notice.
36
-