Telcoma Automations FOX Notice D'instruction page 35

GB
The timer is fixed for a time of approx. 30 seconds and cannot be adjusted.
3. Code erasure
One or more codes may be erased from the memory of the receiver with this
operation.
- Press the key P1 or P24 times during programming.
- The led related to the pressed button gives 5 series of
4 blinks.
- During this stage, transmit with the radio control to be
erased. A fixed led light for a few moments indicates that erasure has been
successful.
4. Erasure of all codes (reset)
The receiver storage is totally erased by carrying out the reset.
- Press key P1 or P2 for at least 10 seconds until the
button LEDs light up simultaneously.
After a few seconds all the LEDs go out, indicating that
erasure is complete.
- Repeat the memorisation procedure.
4
P L
P1
10 sec.
(P2)
35