Telcoma Automations FOX Notice D'instruction page 34

GB
- Brief flash of one led: when transmitting with a correctly memorised radio
control, and the respective relay is activated.
- Simultaneous blinking of all the LEDs: during programming this indicates
that a transmitter that is already enabled is being memorised.
- Alternate blinking of the LEDs: during programming this indicates that the
storage is full.
ADVANCED PROGRAMMING
The mode of operation may be changed in the receiver relay outputs, making
them versatile for various uses.
Attention! Do not set options given in this section with button P1 of the
FOX SR receiver.
1. Single-step output
- During programming press key P2 twice instead of once as described in
paragraph 2 under the heading "Standard programming".
- The led related to the pressed button gives 5 series of
two blinks.
- During this stage, transmit with a transmitter.
- A fixed led light for a few moments indicates that
memorisation has been successful. The P2 output is
now single-step. The output has no magnetic hold, so if
there is a power failure while the relay is activated, the latter deactivates.
2. Timer output
- Press the key P2 3 times during programming.
- The led related to the pressed button gives 5 series of
three blinks.
- Transmit with a remote control during this stage.
- A fixed led light for a few moments indicates that
memorisation has been successful. The P2 output has
now become a timer.
34
2
P2 L2
(P3 - L3)
(P4 - L4)
3
P2 L2
(P3 - L3)
(P4 - L4)
-