Weidmüller Digi-Check 5.2 Mode D'emploi page 20

Digi-Check 5.2 04.12.2003 15:02 Uhr Seite 20
Troubleshooting
Fault Cause
The tester cannot be y Batteries are flat
switched on
The message „Err" y Test voltage is
appears on the dis- greater than 690 V
play
y Tester is faulty
The phase sequence y No proper contact
display does not being made on the
change on transpos- top face of the volt-
ing the test probes age tester
y No earthing
y No proper contact
During the phase test,
the „ " symbol is not being made on the
displayed. top face of the volt-
age tester
y Testing probe not
applied to the lead
conducting voltage
y No earthing
C
Declaration of Conformity
This product complies with the and the EMC Directives
European Directives on Low- 89/336/EEC.
Voltage Appliances, 73/23/EEC,
Fields of application
The tool is intended for use in device. Any misuse will result in
applications as described in the the expiry of all guarantee and
operating instructions only. warranty claims on the part of
Any other form of usage is not the operator against the manu-
permitted and can lead to acci- facturer.
dents or destruction of the
20
Remedy
y Replace batteries
y Disconnect tester
from test voltage
y Ensure proper con-
tact of top face
y Do not wear gloves,
wear shoes without
rubber soles
y Ensure proper con-
tact of top face
y Do not wear gloves,
wear shoes without
rubber soles