Makita CG100D Manuel D'instruction page 10

1
► 1. Holder cap 2. Rod handle
2. Insert the cartridge into the holder.
► 1. Holder
3.
Attach the holder cap by turning it firmly while
holding the holder.
1 2
► 1. Holder cap 2. Holder
4. Push the rod gently until the piston touches the
bottom of cartridge.
To remove the cartridge, follow the installation proce-
dure in reverse.
2
1
Using film type package
Preparing package for use
Cut off the tip of the package.
NOTICE:
Be sure to check the package for dam-
age before installation. Using the damaged pack-
age may cause malfunction.
Installing film type package to 600
ml (20 fl oz) or 800 ml (29 fl oz) size
holder
NOTICE:
Make sure that piston B (for 600 ml
(20 fl oz) holder) or piston E (for 800 ml (29 fl oz)
holder) is attached to the rod. Do not use other
type of piston for film type package.
1. Remove the holder cap, nozzle, and rubber ring
from the holder.
1 2 3
► 1. Holder cap 2. Nozzle 3. Rubber ring 4. Holder
2.
Pull the rod handle backward slowly until it stops.
3. Insert the package into the holder.
10 ENGLISH
4