Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SHAPING PIPES
1
Fit the reflector
nozzle 6
nozzle 1
of the heat gun.
Caution! Make sure the tool and
nozzle are cool and the tool is
switched off and unplugged.
WELDING PLASTIC
1
Fit the reducer
nozzle 7
nozzle 1
of the heat gun.
Caution! Make sure the tool and
nozzle are cool and the tool is
switched off and unplugged.
REMOVING PAINT
1
Fit the protector
nozzle 8
nozzle 1
of the heat gun.
Caution! Make sure the tool and
nozzle are cool and the tool is
switched off and unplugged.
DETACHING GLUE
1
Fit the flat
nozzle 9
zle 1
of the heat gun.
Caution! Make sure the tool and
nozzle are cool and the tool is
switched off and unplugged.
SET TEMPERATURE
1
Slide up the heat selection
set the desired temperature:
1
70 °C
2
450 °C
3
600 °C
onto the heat
2
onto the heat
2
onto the heat
2
onto the heat noz-
2
switch 3
to
2
550 l/min
350 l/min
550 l/min
Make sure the reflector nozzle
securely fitted so that it cannot fall off
during use.
Make sure the reducer
nozzle 7
curely fitted so that it cannot fall off
during use.
Make sure the protector nozzle
securely fitted so that it cannot fall off
during use.
Make sure the flat
nozzle 9
fitted so that it cannot fall off during
use.
Set heat selection switch
switch the tool off.
6
is
is se-
8
is
is securely
3
to 0 to
EN
71
Publicité
Chapitres
Table des Matières
