i-tec U3DVIDOCKL Mode D'emploi page 6

EN
Download the required software from our website www.i-tec.cz/en from the „Download" tab for this
product. Install the drivers according to the following procedure:
For the LAN and DVI-I port run the downloaded file, select the language of the installation and follow the
instructions on the screen.
Note:
In Windows 7 / 8 / 8.1 / 10 install the DVI-I port as the „Administrator". The monitor may be flashing during
the installation of the drivers – this is a standard process. After the completion of the installation we
recommend restarting the notebook / tablet / PC.
HARDWARE INSTALLATION (CONNECTING THE DOCKING STATION TO A NOTEBOOK / TABLET / PC)
1. Turn ON the notebook / tablet / PC and connect the power adapter to the docking station.
2. Connect the power adapter to the AC 110 V / 230 V mains.
3. Connect the USB 3.0 cable to the USB port type B on the back on all of the docking station.
4. Connect the USB 3.0 cable to a free USB 3.0 / 2.0 port of your notebook / tablet / PC.
5. Subsequently, the automatic installation of the ports in the individual systems will start.
INSTALLATION OF DRIVERS IN MAC OS X
Before the first use do not connect the docking station to the MacBook / PC, until you install the
corresponding drivers for the LAN and DVI-I port from www.i-tec.cz/en. The equipment drivers need to be
installed only before the first use.
Download the required software from our website www.i-tec.cz/en from the „Download" tab for this
product. Install the drivers according to the following procedure:
For the LAN and DVI-I port run the downloaded file. Decompress the file on the desktop of your MacBook /
PC as a virtual disc, select "Drivers" and then „DisplayLink Software Installer". Then select the language of
the installation and follow the instructions on the screen. Enter the user password if necessary. The monitor
may be flashing during the installation of the drivers – this is a standard process. After the completion of
the installation restart the MacBook / PC.
HARDWARE INSTALLATION (CONNECTING THE DOCKING STATION TO A MACBOOK / PC)
1. Turn ON the MacBook / PC and connect the power adapter to the docking station.
2. Connect the power adapter to the AC 110 V / 230 V mains.
3. Connect the USB 3.0 cable to the USB port type B on the back panel of the docking station.
4. Connect the USB 3.0 cable to a free USB 3.0 / 2.0 port of your MacBook / PC.
5. Subsequently, the automatic installation of the ports in the individual systems will start.
6. After the completion of the installation restart the MacBook / PC.
SAFETY INSTRUCTIONS
• Do not expose to extreme temperatures and air humidity.
• Use the device on flat surfaces – you will prevent it from slipping and falling to the ground.
• Save the user manual for a possible use later.
In cooperation with the service department:
• Check functionality after falling to water or to the ground.
• Check functionality when the cover is broken.
• Send the device back if it does not work in accordance with the user manual.
FREQUENTLY ASKED QUESTIONS
Available on our website www.i-tec.cz/en on the "FAQ" tab of this product.
6
Quick Start / USB 3.0 Docking Station