Section 1 - Introduction; How To Use This Manual; Packing List; Care & Storage - Ingersoll Rand ETW-E25 Manuel De L'utilisateur

EN

SECTION 1 - INTRODUCTION

HOW TO USE THIS MANUAL

This manual is divided into sections describing the steps to be
taken to configure the Expert Torque Wrench for use in measuring
and recording torque values.
Section 1 is an introduction to the Expert Torque Wrench.
Section 2 describes the controls and features.
Section 3 describes how to configure and use the Expert Torque
Wrench.
The following conventions are adopted throughout this manual:
Keys to be pressed will be shown as the key legend - for example
ENTER. Information displayed on the LCD screen will be
shown within quotation marks i.e. 'Select Fault' or displayed as an
actual screenshot.

PACKING LIST

The following items are supplied with the basic Expert Torque
Wrench unit:
1 x Expert Electronic Torque Wrench
1 x Battery Pack
1 x Square Drive Adapter
1 x Battery Charger
Care & Storage
This unit is designed for indoor use only.
Operating temperature range
Storage temperature range
The membrane keypad may be wiped clean with a soft damp cloth.
The unit is not waterproofed and spillages should be avoided.
THIS UNIT CONTAINS NO USER SERVICEABLE PARTS. ONLY QUALI-
FIED SERVICE PERSONNEL SHOULD REPLACE OR FIT PARTS.

Batteries

Expert Torque Wrench requires ETW-EBP Ingersoll Rand supplied
rechargeable cell pack (battery life - typically 8 hours of continuous
use).

OVERVIEW

Expert Torque Wrench's range of software features can be
individually programmed to give a configuration most suited to
the requirements - from a simple torque wrench to an extensive
tightening control unit.
The Expert Torque Wrench features four measurement modes
that monitor the torque and angle of a fastening operation.
Measurements can be taken for peak values or in real time. The
wrench can even be programmed to indicate when a fastener has
reached a target torque, target angle, or yield point.
EN-3
1 x Aluminum Carry Case
1 x Calibration Certificate
1 x User Manual
1 x RS232 cable
5-40 degrees C
0-50 degrees C
The Expert Torque Wrench is designed to be point of load
insensitive, which means that the operator can be assured of
correct measurement however the wrench is held and torque is
applied - particularly useful in limited access situations.
Expert Torque Wrench is supplied with a dovetail (Sturtevant
Richmont®) interchangeable head fitting, giving a wide range of
head attachments to meet the assembly requirements.
Data from the Expert Torque Wrench can either be printed or
downloaded to a PC using the supplied RS232 cable.
Note: The Expert Torque Wrench cable has a 5 pin round
connector to the wrench. This means the previous 4 pin cables for
earlier Expert Torque Wrench models cannot be used.
PARTS & ACCESSORIES
ETW - EBC
ETW - EBP
ETW - ECC
ETW - ED9B
ETW - CONNECT
ETW - E25 - R04
ETW - E75 - R06
ETW - E180 - R08
04581922
45517257
Battery Charger
Rechargeable Battery Pack
Carry Case
PC Cable
PC Comms Software
Ratchet Drive 1/4" Square
Ratchet Drive 3/8" Square
Ratchet Drive 1/2" Square
User Manual
Safety Information
04581922_ed4