Troubleshooting - Clarke CFP-170 Manuel D'utilisation

Page -26 -

TROUBLESHOOTING

SWIRLS ON THE FLOOR AFTER SCRUBBING
• Floor not clean.
• Incorrect solution.
• Area not properly swept - debris in pad or brush.
• Improper pad or brush for the job.
• Moving the machine too fast.
SWIRLS ON THE FLOOR AFTER DRY BUFFING
• Moving the machine too fast.
• Floor finish too soft.
• Area not properly swept - debris in pad or brush.
• Improper pad or brush for the job.
CIRCLES ON THE FLOOR
• Machine standing still while the brush or pad is
running.
FLOOR FINISH REMOVED
• Improper pad... too aggressive.
• Solution too strong.
MACHINE WOBBLES DURING OPERATION
• Defective pad... one side is more dense than the
other.
• Machine left sitting on brush or pad for extended
period of time causing bristles or pad to "take a
set".
• Pad not "seated" properly into pad holder
bristles.
• Warped block on brush or padholder - replace.
MACHINE DOES NOT RUN
• Check plug for proper connection - on machine
and at wall outlet.
• Check building circuit breaker.
• Call for service.
LIGHT ON 2000DS MOTOR ILLUMINATES
• Stop operating machine within 6 hours
• Call for service
• Replace carbon motor brushes.
®
Clarke Operator's Manual- CFP Polisher