Bimar VT25 Notice D'instructions page 8

Fax +32 030 9904733

1. Insert the lower part of the body in the base (8) (see the figure to the right),
make sure that the 3 hooks come out of their relative slots.
Attention: without the base the fan can not be used.
2. Fasten the rear grid (4) to the motor casing (7), positioning the
corresponding pins and holes (see the figure to the right), and lock using
the appropriate ring nut (3).
3. Couple the front grid (1) to the rear grid (4), blocking with the ring
perimeter plastic; and secure it with the screw with nut, (11) must be in the
lower part. Having done this, check that the protection grid is firmly
coupled and fastened to the motor.
USE
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if the power
cord is damaged, it must be replaced by the manufacturer or a competent qualified electrician or a person
with similar qualifications, in order to avoid any risk.
Insert the plug of the fan in the power supply.
Ventilation: select the desired speed with the selector (9).
1 – Minimum speed 2 – Maximum speed
To turn the fan off, press the "0" key and then remove the plug from the socket.
Horizontal oscillation (right-left): this is selected with the button (6) located on the motor body. To stop
the motion and keep the ventilator still, press the button.
Vertical inclination (high-low): it is regulated by gripping the motor body and orienting it in the
direction desired; you will hear "click" that indicate the fan's various position.
When not in use for long periods, the plug must always be removed from the socket.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar (Italy).
The pages must be reproduced and folded in order to obtain
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don't change the page numbering.
Keep the language integrity.
8 24
/
Assembly page 8/16
1) Front grille
2) Ring perimeter plastic
3) Grille attachment ring nut
4) Rear grille
5) Motor shaft
6) Oscillation button
7) Body
8) Base
9) Selector
10) Fan
11) Screws and nuts for fasten
the grilles