Replacing The Power Cable; Cleaning, Maintenance, Storage, Transport And Ordering Spare Parts - EINHELL RT-TS 1725/1 U Mode D'emploi D'origine

Anleitung_RT_TS_1725_1_U_SPK1__ 20.11.15 06:51 Seite 32
GB
9.3 Cutting particle boards
To prevent the cutting edges from cracking when
working with particle boards, you should not set the
saw blade (5) more than 5mm greater than the
thickness of the workpiece (also see Point 9.2).

10. Replacing the power cable

If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
11. Cleaning, maintenance, storage,
transport and ordering of spare
parts
Always pull out the power plug before starting any
cleaning work.
11.1 Cleaning
Keep all safety devices, air vents and the motor
n
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
down with compressed air at low pressure.
We recommend that you clean the equipment
n
immediately after you use it.
Clean the equipment regularly with a damp cloth
n
and some soft soap. Do not use cleaning agents
or solvents; these may be aggressive to the
plastic parts in the equipment. Ensure that no
water can get into the interior of the equipment.
11.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important. The carbon brushes should not be
replaced by anyone but a qualified electrician.
11.3 Servicing
There are no parts inside the equipment which
require additional maintenance.
11.4 Storage
Store the equipment and accessories out of children's
reach in a dark and dry place at above freezing
temperature. The ideal storage temperature is
between 5 and 30 °C. Store the electric tool in its
original packaging.
11.5 Transport
32
Use only the transport handles (Figure 44)
n
punched into both sides of the housing for
transporting the equipment.
Secure the equipment against slipping; tie it down
n
securely.
Never use the safety devices for handling or
n
transporting purposes.
11.6 Ordering replacement parts
Please provide the following information on all orders
for spare parts:
Model/type of the equipment
n
Article number of the equipment
n
ID number of the equipment
n
For our latest prices and information please go to
www.isc-gmbh.info
13. Disposal and recycling
The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The
equipment and its accessories are made of various
types of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.
Batteries contain materials that are potentially harmful
to the environment. Never place batteries in your
household refuse, in fire or in water. Batteries should
be collected, recycled or disposed of by environment-
friendly means. Send your old batteries to iSC GmbH,
Eschenstrasse 6 in D-94405 Landau. You can then be
sure that the equipment will be correctly disposed of
by the manufacturer.