Items Supplied; Intended Use - EINHELL RT-TS 1725/1 U Mode D'emploi D'origine

Anleitung_RT_TS_1725_1_U_SPK1__ 20.11.15 06:51 Seite 26
GB
17. Push stick
18. Legs
19. Cross struts
20. Longitudinal struts
21. Center struts, short
22. Center struts, long
23. Rubber legs
24. Stability bar
25. Table support, short
26. Table support, long
27. Screw with wing nut
28. Oval hole in splitter
29. Countersunk head screws
30. Fixing screw
31. Eccentric lever
32. Groove
33. Knurled screw
34. Laser
35. Laser switch
36. Screws for battery compartment
37. Battery cover
38. /39. Fixing points

3. Items supplied

Open the packaging and take out the equipment
n
with care.
Remove the packaging material and any
n
packaging and/or transportation braces (if
available).
Check to see if all items are supplied.
n
Inspect the equipment and accessories for
n
transport damage.
If possible, please keep the packaging until the
n
end of the guarantee period.
IMPORTANT
The equipment and packaging material are not
toys. Do not let children play with plastic bags,
foils or small parts. There is a danger of
swallowing or suffocating!
Original operating instructions
n
Saw table to preassembled, carbide-tipped saw
n
blade with 24 teeth
Saw blade guard
n
Extraction hose
n
Splitter with laser
n
Batteries 1.5 V AAA (2x)
n
Parallel stop
n
Stop rail
n
Cross stop
n
Table width extension (2x)
n
Table length extension
n
Push stick
n
26
Legs (4x)
n
Cross struts (2x)
n
Longitudinal struts (2x)
n
Center struts, short (2x)
n
Center struts, long (2x)
n
Rubber feet (4x)
n
Stability bar (2x)
n
Table support, short (4x)
n
Table support, long (2x)
n
Installation material
a) Washer M6 (52x)
b) Nut (38x)
c) Hex screw (52x)
d) Allen screw (6x)
n) Lock bolt (2x)
u) Washer M5 (6x)
v) Retaining clip
Tools
r) Open-ended wrench, size 10/13
s) Ring wrench, size 10/24
t) Allen key, size 4mm

4. Intended use

The bench-type circular saw is designed for the
slitting and cross-cutting (only with the cross stop) of
all types of timber commensurate with the machine's
size. The equipment is not to be used for cutting any
type of round wood.
The equipment may only be used for the tasks it is
designed to handle. Any other use is deemed to be a
case of misuse. The user/operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
equipment is used in commercial, trade or industrial
businesses or for equivalent purposes.
The equipment is to be operated only with suitable
saw blades (saw blades made of HM or CV) It is
prohibited to use any type of HSS saw blade and
cutting-off wheel. To use the equipment properly you
must also observe the safety information, the
assembly instructions and the operating instructions
to be found in these operating instructions.
All persons who use and service the equipment have
to be acquainted with these operating instructions
and must be informed about the equipment's potential