Candy CHK64C Manuel D'instruction page 7

 You should place the bracket on the underneath of the hob, in a position that is
appropriate for the aperture that you have cut out. Using the screws provided, fix
the bracket to the hob. These screws MUST be securely tightened.
ceramic hob is manufactured to work with three-phase
alternating current (400V3N~50Hz).The voltage rating of
the ceramic hob heating elements is 230V. Adapting the ceramic hob to operate with
one-phase current is possible by appropriate bridging in the connection box according
to the connection diagram below. The connection diagram is also found on the cover
of the connection box. Remember that the connection wire should match the
connection type and the power rating of the ceramic hob.
The connection cable must be secured in a strain-relief clamp.
Warning!
Remember to connect the safety circuit to the connection box terminal marked with
.The electricity supply for the ceramic hob must have a safety switch which
enables the power to be cut off in case of emergency. The distance between the
working contacts of the safety switch must be at least 3mm.
Before connecting the ceramic hob to the power supply it is important to read the
information on the data plate and the connection diagram.
CONNECTION DIAGRAM
Caution! Voltage of heating elements is 230V
Caution! ln the event of any connection
the safety wire must be connected to the
For 230 V earthed one-
1
phase connection, bridges
connect 1-2 terminals,
safety wire to .
7
Fitting guidelines
The
1
1 2 3
Recommended
type of connection
4
lead
PE terminal
1 2 3
L1
H05VV-F 3G2.5
4
PE
N
2