Candy CHK64C Manuel D'instruction page 6

 This is a Y-type design built-in ceramic, which means that its back wall and one
side wall can be placed next to a high piece of furniture or a wall .Coating or
veneer used on fitted furniture must be applied with a heat-resistant adhesive
(100℃).This prevents surface deformation or detachment the coating.
 Hoods should be installed according to the manufacturer's instructions.
Assembly of ceramic hob :
 Make an opening with the dimensions given in the diagram for the hob to be
mounted on the worktop．
 Check seal for perfect fit and overall cover. Lower the ceramic hob into place and
align correctly.
 Using a standard screwdriver, tighten the tension clamps evenly starting at the
centre and moving diagonal, until the built-in rim is tight on the worktop.
Cut a hole in the worktop that corresponds with the drawing shown above.
 IMPORTANT: You must observe the ventilation
requirements shown in the drawing opposite.
 IMPORTANT: There are ventilation holes around the
outside of the hob. YOU MUST ensure that these
holes are not blocked by the work top, when you put
the hob into position (see drawing opposite).
 IMPORTANT: Do not use a silicon sealant to seal the
appliance against the aperture. This will make it
difficult to remove the hob from the aperture in future,
particularly if it needs to be serviced.
 Carefully turn the hob back over and then gently lower it into the aperture hole
that you have cut out.
 There are holes on the base or the sides of the hob that you can fix the four
brackets to. There are three holes in each one of the brackets.
6