ResMed ClimateLineAir Mode D'emploi page 7

Cleaning
You should clean the air tubing weekly as described.
1. Wash the air tubing in warm water using mild detergent.
Do not wash in a dishwasher or washing machine.
2. Rinse the air tubing thoroughly and allow to dry, out of
direct sunlight and/or heat.
Checking
You should regularly check the air tubing for any damage. If
there are any holes, tears or cracks you should replace it.
Reconnecting the air tubing
When the air tubing is dry, you can reconnect it to the device.
1. Connect the air tubing firmly to the air outlet located on
the rear of the device.
2. Connect the free end of the air tubing firmly onto the
assembled mask.
Troubleshooting
If you have any problems, refer to the troubleshooting section
of your device user guide or www.resmed.com.
Note: For any serious incidents that occur in relation to this
device, these should be reported to ResMed and the
competent authority in your country.
Technical specifications
Environmental conditions
Operating temperature:
Operating humidity:
Operating altitude:
Storage and transport temperature:
Storage and transport humidity:
Electromagnetic compatibility / Air tubing resistance to flow and
compliance values
Refer to the device User Guide.
Temperature
Temperature range:
Cut-out:
Operating pressure range
Maximum recommended pressure
6
+41°F to +95°F (+5°C to +35°C)
Note: The air flow for breathing
produced by this therapy device can
be higher than the temperature of
the room. Under extreme ambient
temperature conditions (104°F/40°C)
the device remains safe.
10 to 95% relative humidity, non-
condensing
Sea level to 8,500' (2,591 m); air
pressure range 1013 hPa to 738 hPa
-4°F to +140°F (-20°C to +60°C)
5 to 95% relative humidity, non-
condensing
+60 to +86°F (+16 to +30°C)
+106°F (+41°C)
30 cm H O (30 hPa)
2