Schémas De Navigation De Menu Du Travail En Bandes De Base - Raven RGL 600 SMARTBAR Manuel D'utilisation

Schémas de navigation de menu de travail en bandes de base
Conditions du Schéma n°1 de navigation de menu :
La mesure par ruban est désactivée
La commande de tournières est désactivée
La direction est automatique
Les marques A-B n'ont pas été paramétrées
Power
RGL 600
ON
Increase
Brightness
Operational Mode
Menu Navigation Diagram #1
Main Screen
RGL 600
Display Display
Brightness Brightness
Adjust Adjust
Screen Screen
A-B Line A-B Line
Setup Setup
enter
Configuration
Mode
if A is
SET A
not set
Set the
BRT
A
Decrease
Brightness
To mark Temp B To mark Temp B
if A is
SET B
set
Set the
B
Mark Mark
Automatic (no button press)
press SELECT Button
press MENU Button
press DOWN Button
press and hold MENU Button
Firmware Version *2.3 Firmware Version *2.8
Turn Left or Right toward field Turn Left or Right toward field
if A-B
AUT DIR
are set
turn toward
Swath #2
Set
Direction
to
Menu Navigation
Diagram #2
Hold 3 sec. Hold 3 sec.
to CFG to CFG
SELECT increases SELECT increases
brightness. brightness.
DOWN decreases DOWN decreases
brightness. brightness.
SELECT increases SELECT increases
Swath Width Swath Width
DOWN decreases DOWN decreases
Swath Width. Swath Width.
Press SELECT Press SELECT
to mark A. to mark A.
Press SELECT Press SELECT
to mark B. to mark B.
Down for temp B. Down for temp B.
Turn toward Turn toward
Swath 2. Swath 2.
Direction will Direction will
set Automatically. set Automatically.