DISCONNECT DEVICE
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect
device shall remain readily operable.
DMX CONNECTION
Connect an XLR cable to the male 3-pin XLR output of your controller and the other side to the fe-
male 3-pin XLR input of the device.
MENU DISPLAY
Button functions:
MENU: Press to go to the next page. In an operating mode, press to exit the mode.
UP: Increase the value, or set up the timer
DOWN: Decrease the value, or set up the volume
ENTER: Exit, or to start the fog output mode and go back to the menu
When "Uni-Fogger'' is displayed on the screen:
1.
Press UP button to choose the timer and the volume mode
2.
Press DOWN button to go to fog output status
3.
Press ENTER button to stop working and go back to the menu
No.
Menu
1.
Unit-Fogger
2.
Interval Setting (5-200s)
3.
Duration Setting (5-200s)
4.
DMX address setting (1-512)
5.
Fluid Sensor (0-1)
6.
Fog output volume setting (1-100)
7.
Timer out and volume setting (1-100)
8.
Red Color setting (0-100)
9.
Green Color setting (0-100)
10.
Blue Color setting (0-100)
11.
Strobe speed setting (0-100)
12.
LED color jump speed setting (0-100)
13.
LED color fade speed setting (0-100)
14.
Outer RGB Color setting
15.
Outer strobe speed setting (0-100)
16.
Outer LED color jump change speed setting (0-100)
17.
Outer LED color fade changing speed setting (0-100)
www.afx-light.com
3
EN