ECG MTD 2080 VGSS Mode D'emploi page 76

INSTALLATION
Names of the oven parts
1 Cabinet
2 Upper tunnel
3 Screw 4×8
4 Screw 4×10
5 Frame
6 Microwave oven
7 Screw 3×25
8 Feet extension
Remove all packaging material and take out all
accessories.
GB
Check if the oven is not damaged (dented or
damaged door, etc.) Do not install the microwave
oven if damaged.
Oven body: Remove all the protective foil from
the surface of the oven.
Do not remove the rectangular cover that is attached inside the oven. This cover protects the
magnetron of the oven.
Installation
1. Place the oven on a flat surface with a sufficient amount of space around the appliance to ensure the
proper function of exhaust vents.
a) Do not block the ventilation openings. The oven could be damaged.
b) Place the oven as far as possible from any radio and television.
A microwave oven may cause interference of TV and radio TV signals.
2. Install the extensions of the oven feet (viz figure 1).
3. Attach the upper tunnel with 4 screws (3). Make sure that the open part is in the back, see figure 2.
4. Use four screws (4) to attach the frame, see figure 3.
ATTENTION: The top part of the interior side of the frame is marked by letters TOP.
5. Place the microwave oven in the cabinet, see figure 4. Do not cover the ventilation/intake openings
in any way. Place the oven in the middle of the cabinet.
6. Attach the oven using 4 screws (7), see figure 5.
3
7. Connect the oven to a standard electricity network. Make sure the voltage and frequency on the oven label
corresponds with the network voltage and frequency.
WARNING: If the grounded outlet is not accessible after installing the appliance, then the oven must be plugged
into a two-pole spur outlet, equipped with a switch and fuse with 3 mm contact separation and placed
in an easily accessible location next to the device. The sput outlet must always be accessible even when
the oven is placed in the cabinet.
76
Ventilation opening
1
1
4
4
1
1
4
4
4
4
1
2
8
1
2
5
3 4
5
6
7
3
7
Hot surface!