TFA 60.2547 Mode D'emploi page 12

TFA_No. 60.2547_Anleitung_12_21
Radio-controlled alarm clock
• Protect it from moisture.
• Clean the device with a soft damp cloth. Do not use solvents or scour-
ing agents.
3. Elements
A: Display (Fig. 1):
A 1: AM/PM
A 2: Time
A 3: Symbol Daylight Saving Time (DST)
A 4: Alarm time 1 (activated)
A 5: Day of the week
A 6: DCF reception symbol
A 7: Seconds
A 8: Alarm time 2 (activated)
A 9: Date/alarm time 1
A 10: Temperature and humidity/alarm time 2
B: Buttons (Fig. 1-3):
B 1: SNOOZE/LIGHT button
B 2: AUTO LIGHT ON/OFF switch
B 3: WAVE button
B 4: TIME button
22
18.12.2021 12:01 Uhr Seite 12
Radio-controlled alarm clock
B 5: ALARM Taste
B 6: ALARM 1 ON/OFF switch
B 7: + button
B 8: – button
B 9: ALARM 2 ON/OFF switch
C: Housing (Fig. 1-3):
C 1: Light sensor
C 2: Battery compartment
4. Getting started
• Open the battery compartment and insert two new AA 1,5 V batteries.
Make sure the polarity is correct.
• Close the battery compartment again.
• The device will alert you with a beep and all segments will be displayed
for a short moment.
• The display shows the current temperature and humidity.
• The clock will now scan the DCF frequency signal and the DCF symbol
will be flashing on the display. When the time code is successfully
received after 3-7 minutes, the radio-controlled time, the date and the
DCF symbol will be shown steadily on the display.
23