Ferm WSM1009 Traduction De La Notice Originale page 9

● To switch off the machine, release the on/off
switch (1).
Overload protection
The machine is equipped with an overload
protection device which automatically switches off
the machine if the machine is overloaded.
● Switch off the machine.
● Remove the machine from the workpiece.
● Switch on the machine.
● Run the machine at no-load for approximately
1 minute to allow the machine to cool down.
Using the laser (fig. A)
The laser is used for projection of the cut on the
wall.
● To switch on the laser (8), press the on/off
switch (7).
● To switch off the laser (8), release the on/off
switch (7).
Dust extraction (fig. G)
Only use the machine when it is connected to a
vacuum device which is approved for stone dust.
The vacuum device must be suitable for the
material to be worked. Use a special vacuum
device when working with toxic materials or
2
where toxic dust is produced.
- Never use a household vacuum cleaner.
The use of a household vacuum cleaner can
easily damage both your health and the
vacuum cleaner.
- Always use the dust extraction adapter.
- Make sure that the hose of the vacuum device
is securely connected to the dust extraction
adapter.
- If the vacuum device breaks down, stop work
immediately, switch off the machine, remove
the mains plug from the mains, and try to solve
the problem.
● Insert the dust extraction adapter (26) into the
dust extraction connection (12).
● Connect the hose of a vacuum device to the
dust extraction adapter (26).
Hints for optimum use
● Draw lines to define the direction in which to
guide the cutting discs.
● Hold the machine with both hands.
● Set the slot width.
● Take one of the following steps:
- Lower the machine into the wall and set the
slot depth (recommended). The machine is
placed against the wall and the cutting discs
lower into the wall in order to set the slot
depth more accurately.
- Set the slot depth and lower the machine
into the wall.
● Place the machine with the guide roller on the
wall. Make sure that the cutting discs align
with the drawn lines on the wall.
● Set the slot depth.
● Switch on the machine.
● Wait until the machine has reached full speed.
● Slowly move the machine along the pre-drawn
lines from top to bottom, firmly pressing the
guide roller against the wall (fig.I).
● Do not apply too much pressure on the
machine. Let the machine do the work.
● Switch off the machine and wait for the
machine to come to a complete standstill
before putting the machine down.
CLEANING AND MAINTENANCE
4
Before cleaning and maintenance,
always switch off the machine and
remove the mains plug from the mains.
● Regularly clean the housing with a soft cloth.
● Keep the ventilation slots free from dust and
dirt. If necessary, use a soft, moist cloth to
remove dust and dirt from the ventilation slots.
● Regularly clean the cutting discs to avoid
inaccuracies during use.
Replacing the batteries (fig. H)
The laser uses 2 AAA batteries. If the laser stops
working, the batteries must be replaced.
● Remove the cover (27) from the battery
compartment (9).
● Remove the old batteries (28).
● Place the new batteries (28).
● Mount the cover (27) to the battery
compartment (9).
WARRANTY
Consult the enclosed warranty terms.
ENVIRONMENT
Disposal
The product, the accessories, and the packaging
must be sorted for environmentally friendly recycling.
9