Brita SAFF-100 Guide De L'utilisateur page 11

Performance testing conducted by NSF International. This system has been tested according to NSF/ANSI Standards 42, 53
and 401 for reduction of the substances listed. The concentration of each of the indicated substances in water entering the
system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as specified in
NSF/ANSI Standards 42, 53 and 401.
System tested at 60 psig (414 kPa) using a minimum flow rate of 0.58 gpm (2.19 L/min).
Testing was performed under standard laboratory conditions. The contaminants or other substances removed or reduced
by this water treatment system are not necessarily in all users' water. Filter performance may vary based on local water
conditions. The compounds certified under NSF/ANSI 401 have been deemed as "incidental contaminants/emerging
compounds." Incidental contaminants are those compounds that have been detected in drinking water supplies at trace levels.
While occurring at only trace levels, these compounds can affect the public acceptance/perception of drinking water quality.
The Brita® Faucet Filtration System is not intended to purify water. Do not use with water that is microbiologically unsafe
or of unknown quality without adequate disinfection before or after the system. Individuals requiring water of special
microbiological purity should follow the advice of their doctor or local health officials regarding the use and consumption
of their tap water and Brita water.
Capacity: Service Flow Rate:
100 gallons 0.58 gpm
(378 liters) (2.19 L/min)
Please refer elsewhere in this User's Guide for the proper installation, conditioning, use and care requirements and an
explanation of how the filter replacement indicator functions. Maintenance according to the manufacturer's instructions is
essential for proper filter performance. Filter life should not exceed 100 gallons. If a decrease in flow rate is noticed, replace
the filter earlier. Replacement filters (model FR-200) are available in one-pack, two-pack, three-pack and four-pack sizes. For
more information visit brita.com (USA) or brita.ca (Canada).
The Brita® Faucet Filtration System has been tested and certified by NSF International
against NSF/ANSI Standards 42, 53 and 401 for the reduction of the claims specified
on the Performance Data Sheet.
The Brita® Faucet Filtration System has been tested and certified by the WQA against
NSF/ANSI Standards 42, 53 and 401 for the reduction of the claims specified on the
Performance Data Sheet.
Distributed in U.S.A. for: Brita LP, 1221 Broadway, Oakland, CA 94612; 1-800-242-7482
Distributed in Canada by: Brita Canada Corporation, 150 Biscayne Crescent, Brampton, ON L6W 4V3; 1-800-387-6940
FOR PURCHASES MADE IN IOWA: This form must be signed and dated by the buyer and seller prior to the consummation of
this sale. This form should be retained on file by the seller for a minimum of two years.
BUYER:
Name
Address
Signature
Date
Working Pressures (min./max.):
20 psig/100 psig
(138 kPa/689 kPa)
2 2
(1.4 kg/cm /7.0 kg/cm )
SELLER:
Name
Address
Telephone Number
Signature
Date
10
Filtered Water
Temperature (min./max.):
34°F/100°F (1°C/38°C)
Electrical Requirements:
None