Blowing Feature - RIDGID RV24000 Mode D'emploi

SP6729-1 RIDGID ESF_SP6636 2/12/13 8:32 AM Page 14
Operation (cont.)

Blowing Feature

Your Vac features a blowing port. It can
blow sawdust and other debris. Follow the
steps below to use your Vac as a blower.
1. Locate blowing port of your Vac.
WARNING: Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a blower.
WARNING: To reduce the risk of
injury to bystanders, keep them
clear of blowing debris.
CAUTION: Wear a dust mask if
blowing creates dust which might
be inhaled.
CAUTION: To reduce the risk of
hearing damage, wear ear protectors
when using the Vac/Blower for
extended time or in a noisy area.
2. Insert the locking end of the "Tug-A-
3. (Optional) Attach extension wand to
4. Turn Vac on and you are ready to use
Tug-A-Long
Hose
14
Long™"hose into the blowing port of
the Vac. The hose should snap into
place. To remove the hose from the
Vac, press the release button in the
hose assembly and pull the hose out of
the Vac inlet.
opposite end of hose.
your Vac as a blower.
Blowing
Port