After Use / Cleaning The Device - Maxx-world Z 03331 Mode D'emploi

EN
6. You can use the On/Off switch / steam quantity control (16) to change the quantity
of steam. Turn it to MAX to increase the quantity of steam and to MIN to reduce it.
However, make sure that you do not turn the control to the OFF position and switch
off the production of steam.
7. If the control lamp switches to red, the temperature has dropped. Let go of the steam
release button and only press it again when it is blue.
8. Once the water reservoir is empty, steam will no longer be produced. If you want to
top up the water in the reservoir (see the "Filling the Water Reservoir" chapter) or
want to stop work, turn the On/Off switch / steam quantity control to the OFF posi-
tion, pull the mains plug out of the plug socket and allow the device to cool down
completely.
9. Empty and clean the water reservoir each time after you use the device (see
below) to prevent deposits in the reservoir and thus damage to the device!

After Use / Cleaning the Device

CAUTION!
• Empty and clean the water reservoir each time after you use the device to prevent
deposits in the reservoir and thus damage to the device!
• Always pull the mains plug out of the plug socket when you are not using the device,
before you open the water reservoir or remove an attachment.
• The attachment, hose and the water in the reservoir may still be hot shortly after use.
You should therefore wait until they have completely cooled down before you remove
the attachment or empty the water reservoir.
• Never immerse the device in water or other liquids!
• Never touch the device, the cable or the plug with wet hands.
• The steam cleaner should be regularly descaled with a standard commercial descal-
ing agent in order to extend the useful life of the steam cleaner. Note the manufac-
turer's instructions on the packaging of the descaling agent.
• Do not use any caustic or abrasive cleaning agents or cleaning pads to clean the
device. These can damage the surface.
• Empty the water reservoir. Twist the reservoir cap towards the
it. Hold the device over a sink or similar outlet and allow all of the water to run out of
the reservoir.
• Wash the cleaning cloth after every use in accordance with the washing instructions.
• Clean the attachments if necessary with clear, warm water.
• If necessary, wipe down the outside of the device with a soft, slightly damp cloth and
dry it with a soft cloth.
• Allow all device and accessory parts to dry completely before you store them in a
clean and dry place that is inaccessible to children.
22
symbol and remove