Filling The Water Reservoir - Maxx-world Z 03331 Mode D'emploi

EN
Scraper Lip
• Attaching: Plug the scraper lip (6) onto the handle (21). If necessary, rotate the scrap-
er lip until the locking lug of the handle is recessed in the opening of the scraper lip.
• Removing: Press down the locking lug and pull the scraper lip away from the handle
at the same time.
Cleaning Cloth
1. Plug the cleaning cloth holder (7) onto the handle (21). The cleaning cloth holder is
attached and removed in exactly the same way as the scraper lip (6) (see above).
2. Pull the cleaning cloth (2) over the cleaning cloth holder and pull the drawcord tight.
Steam attachmet and Brushes
Carrying Strap
• Attach the two spring hooks of the carrying strap (4) to the loops (18) on each side
of the steam cleaner.

Filling the Water Reservoir

CAUTION!
• Always pull out the mains plug before you top up/empty the water reservoir. Always
pull the plug and never the cable.
• Allow the device to cool down completely before pouring in water. Otherwise there
could be an uncontrolled emission of steam.
• Do not overfi ll the water reservoir. Pour a maximum of 900 ml of water into the device.
• Never hold the device below a tap and never immerse it in water to fi ll up the reservoir
with water.
• Never pour any cleaning agent or other additives into the device. This could destroy
the device and safe working is no longer guaranteed.
20
1. Plug the steam attachment and brush adapter (1) onto the
handle (21).
• In order to remove the brush adapter, press the release
button (19) and pull the brush adapter away from the han-
dle at the same time.
2. Plug a brush onto the brush adapter until it is fi rmly fi xed.
• To remove the brush, simply pull it off.