Introduction; Layout; Scope Of Delivery - Scheppach HS80 Traduction Du Mode D'emploi Original

1. Introduction

Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear customer,
We hope you have a lot of fun and success using your
new machine.
Note:
According to the applicable product liability law the
manufacturer of this device is not liable for damages
which arise on or in connection with this device in
case of:
• improper handling,
• non-compliance with the instructions for use,
• repairs by third party, non-authorised skilled work-
ers,
• installation and replacement of non-original spare
parts,
• improper use,
• failures of the electrical system due to the non-
compliance with the Australian specifications and
regulations.
Recommendations:
Read the entire text of the operating instructions prior
to the assembly and operation of the device.
These operating instructions are intended to make it
easier for you to get familiar with your device and uti-
lise its intended possibilities of use.
The operating instructions contain important notes on
how to work safely, properly and economically with
your machine and how to avoid dangers, save repair
costs, reduce downtime, and increase the reliability
and working life of the machine.
In addition to the safety regulations contained herein,
you must in any case comply with the applicable reg-
ulations of your country with respect to the operation
of the machine.
Put the operating instructions in a clear plastic folder
to protect them from dirt and humidity, and store them
near the machine. The instructions must be read and
carefully observed by each operator prior to starting
the work. Only persons who have been trained in the
use of the machine and have been informed on the
related dangers and risks are allowed to use the ma-
chine. The required minimum age must be met.
In addition to the safety notes contained in the present
operating instructions and the special regulations of
your country, the generally recognised technical rules
for the operation of identically constructed machines
must be observed.
22 І GB 22

2. Layout

(Abb 1-19)
1. Table extension
2. Mitre gauge
3. Table insert
4. Riving knife
5. Saw blade cover with suction port
6. Saw blade
7. Saw table
8. Movable fence
9. Rip fence
10. Star grip
11. Locking handle
12. Height adjustment handle
13. Angle adjusting wheel
14. Scale for the angle adjustment
15. ON/OFF switch
16. Reset button
17. Push stick
18. Main connection
19. Fold-out support feet
A. Suction port
B. Saw blade key
C. Flange key
D. End caps
E. Screws
F. Guide tubes
G. Guide sleeves
H. Star grip screws
J. Locknuts
K. Height adjustment screw
L. Knob
M. Knob
N. Clamping claws
P. Screw
Q. Knurled screws
R. ScrewS
S. Allen screws

3. Scope of delivery

1 Table saw
1 Foldable extension table
1 Saw blade cover (5)
1 Push stick (17)
1 Rip fence (9)
1 Movable fence (8)
1 Mitre gauge (2)
1 Saw blade key (B)
1 Flange key (C)
2 Star grip (10)
2 End caps (D)
2 Screws (E)
2 Clamping claws (N)
1 Instruction manual