Safety Notes - Monacor PA-1120DMT Mode D'emploi

16 Control LEVEL to adjust the volume of the
replay
17 Connection plate to be mounted on the rear side
of the amplifier
18 Jumper J1 to adjust the output level
(position hi = +10 dB)
19 Switching input to trigger the replay of an emer-
gency message (M6); to be connected to the
corresponding connection cable of the amplifier
20 Additional audio output with a stereo signal
(not required when used with amplifiers from
MONACOR)
21 Jumper PLAY MODE SELECTOR to select the
replay mode for the messages M1 – M6
replay after the button START/ STOP
(14) or
pressed
immediate (multiple) replay when the
message is selected by means of the
buttons M1 – M6 (15)
22 Additional input for DCF77 radio clock signals
[not required when used with amplifiers from
MONACOR as the connection is made via the
terminals of the connection plate (17)]
23 Connection jack for remote control via the zone
paging microphone PA-1120RC, PA-6000RC or
PA-2500RC; to be connected to the correspond -
ing connection cable of the amplifier
24 Jack for connection to the connection plate (17)
via the ribbon cable supplied
25 Jack for power supply and for the audio output;
to be connected to the corresponding connec-
tion cable of the amplifier
26 "Busy" LED, will light up during recording and
replay
REPEAT/ STOP (13)

2 Safety Notes

The insertion module corresponds to all relevant
directives of the EU and is therefore marked with
.
G
The insertion module must be installed by skilled
personnel only.
G
The insertion module is suitable for indoor use
only. Protect it against dripping water and splash
water, high air humidity and heat (admissible
ambient temperature range: 0 – 40 °C).
G
Do not operate the unit with the installed insertion
module and immediately disconnect the unit from
the power supply
1. if the insertion module, the unit or the mains
was
cable is visibly damaged,
2. if a defect might have occurred after the unit
was dropped or suffered a similar accident,
3. if malfunctions occur.
In any case the insertion module or the entire unit
must be repaired by skilled personnel.
G
For cleaning only use a dry, soft cloth; never use
water or chemicals.
G
No guarantee claims for the insertion module and
no liability for any resulting personal damage or
material damage will be accepted if the insertion
module is used for other purposes than originally
intended, if it is not correctly installed or oper-
ated, or if it is not repaired in an expert way.
If the insertion module is to be put out of
operation definitively, take it to a local recy-
cling plant for a disposal which is not harm-
ful to the environment.
GB
15