Before Connecting, You Should; Before Connecting; Getting Started; Getting Started With Your Refrigerator - Brandy Best TOP55 Notice D'emploi

Before connecting, you should:

Make sure the plug is compatible with the power cord of the device. If this is not the case, contact a specia-
list technician for assistance..
CAUTION: THIS APPLIANCE MUST BE EARTHED

Before connecting:

DO NOT CONNECT THE REFRIGERATOR AFTER MOVING IT, LEAVE IT FOR MINIMUM 24 HOURS.
The coolant indeed needs to remain at rest before the first ignition.
Before placing food in your refrigerator, let it run for 24 hours to ensure proper operation and to help it
reach the correct temperature.

Getting Started

Before placing drinks in your appliance, leave it on for 24 hours to ensure that it is working properly and to
allow it to reach the correct temperature.

Getting started with your refrigerator

1. Before connecting the refrigerator, check that the thermostat is in position 0. It is located on the right in-
side the appliance.
2. Then turn the thermostat knob to the desired position. Be aware that the higher the number, the colder
the temperature inside the refrigerator.
3. Wait 24 hours before placing food in the refrigerator, so that the refrigerator goes down to the chosen
temperature.
NOTE: Do not store flammable gases or liquids in the unit.
Lamp

Adjusting the temperature

The temperature inside your refrigerator is controlled by the thermostat. There are 7 positions.
Position 7 makes the refrigerator cooler.
Position 1 makes it less cold and position 0 is to turn it off.
The recommended position for the device is between position 1 and 4 depending on the environment.
The refrigerator may not operate at the correct temperature if it is in a particularly hot or cold room or if you
open the doors too often.
Thermostater lever 0 to 5
9