Levelling The Mini-Bar; Cleaning Before Use; Before Connecting, You Must; Start-Up - Brandy Best SILENTPRO35 Notice D'emploi

Levelling the mini-bar

Once the mini-bar is in its final position, ensure that it is level. Adjustments can be made using the two le-
velling feet at the front of the mini-bar.
If the appliance is not level, the alignment of the doors and the magnetic contacts will be affected.

Cleaning before use

Wipe the interior of the mini-bar with a mild solution of bicarbonate of soda. Then rinse with hot water using
a sponge or a wrung cloth. Wipe the appliance in its entirety until there is no more water, then replace the
shelves and drawers. You can clean the exterior with a mild detergent.

Before connecting, you must:

Check that the plug is compatible with the power cable of the appliance. If this is not the case, contact a
specialist technician for assistance.
CAUTION: THIS APPLIANCE MUST BE GROUNDED.

Start-up

Before putting drinks in your mini-bar, leave it running for 24 hours to ensure that it is functioning properly,
and to allow it to reach the correct temperature.

Mini-bar start-up

Depending on the versions:
If your appliance is equipped with an adjustable thermostat, all you have to do is plug in the mini-bar and
set a temperature on the potentiometer located at the back of the product. (see diagram below)
If your version is not equipped with an adjustable thermostat then the interior temperature will be preset to
±8°C
NOTE: Do not store flammable gases or liquids in the mini-bar.
Low temperature
±6 à 8°C
±16°C
±12°C
High temperature
Page 8