Changing The Drum Light (On Some Models); Check Your Vent System For Good Airflow; Maintain Good Airflow - Amana W11361424A Guide D'utilisation

3. Wet a nylon brush with hot water and liquid detergent. Scrub
lint screen with the brush to remove residue buildup.
4. Rinse screen with hot water.
5. Thoroughly dry lint screen with a clean towel. Reinstall screen
in dryer.
Changing the Drum Light (on some
models)
1. Unplug dryer or disconnect power.
2. Open the dryer door. Locate the light bulb cover on the back
wall of the dryer. Using a Phillips-head screwdriver or 1/4"
(6.35 mm) nut driver or socket wrench, remove the screw
located in the lower right-hand corner of the cover. Remove
the cover.
3. Turn bulb counterclockwise. Replace the bulb with a 10 W
appliance bulb only. Replace the cover and secure with the
screw.
4. Plug in dryer or reconnect power.
Accessories and replacement parts are available for your model.
For ordering and contact information, please reference your Quick
Start Guide.
6
Check Your Vent System for Good
Airflow
WARNING
Use a heavy metal vent.
Do not use a plastic vent.
Do not use a metal foil vent.
Failure to follow these instructions can result in death or
fire.
Good Airflow
Along with heat, dryers require good airflow to efficiently dry
laundry. Proper venting will reduce your drying times and improve
your energy savings. See Installation Instructions.
The venting system attached to the dryer plays a big role in good
airflow. Blocked or crushed vents as well as improper venting
installation will reduce air flow and dryer performance.
Service calls caused by improper venting are not covered by the
warranty and will be paid by the customer, regardless of who
installed the dryer. To clean or repair venting, contact a venting
specialist.

Maintain Good Airflow

� Cleaning your lint screen before each load.
� Replace plastic or foil vent material with 4" (102 mm) diameter
heavy, rigid vent material.
� Use the shortest length of vent possible.
� Use no more than four 90° elbows in a vent system; each bend
and curve reduces airflow.
� Remove lint and debris from the exhaust hood.
� Remove lint from the entire length of the vent system at least
every 2 years. When cleaning is complete, be sure to follow
the Installation Instructions for final product check.
� Clear away items from the front of the dryer.
Fire Hazard