Available Accessories - Amana W11361424A Guide D'utilisation

Pliers or slip-joint pliers
Utility knife
Caulking gun and compound
(new vent installations)
Vent clamps
8" (203 mm) or 10" (254 mm)
pipe wrench
Pipe-joint compound resistant
to propane gas
8
Tape measure
Tin snips (new vent
installations)
Adjustable wrench that opens
to 1" (25 mm) or hex-head
socket wrench
Putty knife
Wire stripper (direct-wire
installations)
Parts Supplied (all models):
Leveling legs (4) (Length and appearance of legs may vary
according to model)
Parts package is located in dryer drum. Check that all parts are
included.
NOTE: Do not use leveling legs supplied with dryer if installing
with a pedestal or a stack kit.
Parts Needed (steam models):
"Y" connector
Rubber washer
Parts Needed (not supplied with dryer):
Additional parts may be required, depending on your installation.
Check local codes. Check existing electrical supply and venting.
See "Electrical Requirements" and "Venting Requirements" before
purchasing parts.
Mobile home installations require metal exhaust system hardware
available for purchase from the dealer from whom you purchased
your dryer. For further information, please refer to the Quick Start
Guide for service contact information.

Available Accessories:

Refer to your Quick Start Guide for contact and ordering
information.
2' (0.6 m) inlet hose
5' (1.52 m) inlet hose