AEG RA 5587 Mode D'emploi page 31

Levels/Heating Power
1. Switch on the appliance with the power switch.
2. Press the button
1 X for high power
2 X for medium power
3 X for low power
4 X and the appliance goes to Standby.
NOTE:
• Select low power for e. g. a small room. If this is not
sufficient, switch to the medium or high setting.
• The power settings are shown by (
the display.
Setting the temperature
1. Switch the appliance on.
2. Press the button. The number "88" flashes on the
display.
3. Press the MODE button. The number 24°C or 75°F and
a thermometer symbol appear on the display. The ther-
mometer symbol flashes.
4. Use the °C/°F button to select the temperature display in
degrees Celsius or in degrees Fahrenheit.
5. Use the " / " buttons to set the desired room tempera-
ture. The values can be read off the display.
NOTE:
• The radiator will now warm up the room. The ther-
mometer symbol flashes throughout.
• When the desired temperature is reached, the ther-
mometer symbol stops flashing and is constantly lit.
• The thermometer symbol flashes again as soon as the
radiator needs to be heated up again.
• Use the " / " buttons to change the desired room
temperature at any time.
Program the Switch-off Timer
(AUTO OFF)
Do you want to determine when the radiator should auto-
matically switch off?
1. Press the MODE button again as soon as you have set
the temperature. "AUTO OFF" flashes on the display.
2. Use the " / " buttons to set a time between 1 and
24 hours. The figure can be read off the display.
3. After around 10 seconds, the "AUTO OFF" display stops
flashing and is constantly lit. The radiator will switch off at
the desired time.
Program the Switch-on Timer (AUTO ON)
Do you want to determine when the radiator should auto-
matically switch on?
1. Press the MODE button twice after you have set the
( )
temperature. "AUTO ON" flashes on the display.
( )
2. Use the " / " buttons to set a time between 1 and
( )
24 hours. The figure can be read off the display.
3. After around 10 seconds, the "AUTO ON" display stops
flashing and is constantly lit. The radiator will switch on at
the desired time.
NOTE:
) symbols on
The "AUTO OFF" and "AUTO ON" functions cannot be
combined.
Frost Guard Function
Are there rooms in your house which you would like to pro-
tect against frost? The radiator has a frost guard function.
1. Connect the radiator to a 220-240 V~, 50 Hz earthed
socket.
2. Switch on the power switch. The power indicator lights
up, the display remains dark.
3. If the temperature falls to below 5 °C, the radiator
switches on at setting 3. The display lights up.
4. As soon as the room has been warmed, the radiator
switches back to Standby. The display switches off.
Shutting Down
1. Press the
2. Switch the power switch to "0". The power indicator
switches off.
3. Disconnect the plug from the mains.
Storage
WARNING:
Since the housing and metal parts become hot during op-
eration, allow the appliance to cool before you put it away.
• Clean the appliance as described and allow it to dry
completely. We recommend that you keep the appliance
in the original packaging if you do not want to use it for
long periods.
• Use the handle to pull the appliance. Do not pull on the
cable!
• Always keep the appliance out of the reach of children in
a well-ventilated and dry place.
Cord wind-up station for power cord
The power cord can be wound up on the front of the appli-
ance.
English
button until the display switches off.
31