Publicité
Les langues disponibles
Les langues disponibles
Setting up a DMX Serial Data Link
1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3
pin connector of the controller.
2. Connect the end of the cable coming from the controller which will have a
(female) 3 pin connector to the input connector of the next fixture consisting of
a (male) 3 pin connector.
3. Then, proceed to connect from the output as stated above to the input of the
following fixture and so on.
Connection to the Mains
Connect the power supply unit to the power input jack and the mains plug to a mains
outlet. Always disconnect the mains connector when you wish to change connections,
move the unit to a different place or if it is not used for a longer period.
Configuration
Adjusting the DMX Starting Addresses of the Light Effect Units
Adjust the DMX starting address of the connected light effect units according to the
following scheme. If identical units are to be controlled synchronously, they can
receive the same starting address; otherwise each unit must receive an individual
address. For further information, please refer to the unit's documentation.
Unit
Starting address
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Table 6.1 Default values for the starting address of the light effect units
©Copyright Lotronic 2018
Unit
1
19
37
55
73
91
109
127
145
163
181
199
217
235
253
271
Manual DMX512-PRO
Starting address
17
18
19
20
21
22
23
24
25
26
27
18
29
30
31
32
289
307
325
343
361
379
397
415
433
451
469
199
505
free
free
free
6
Publicité
