Publicité
Les langues disponibles
Les langues disponibles
• If necessary, use the button PAGE to switch between the two channel groups 1-16
and 17-32.
Fig. 7.10 Adjusting the first scene
6. Adjust the first illumination scene with the sliding controls and, if necessary the
pan and tilt wheels.
• The display indicates the number of the control channel in the lower line and the
current output value as a DMX value.
7. It is also possible to call a scene previously memorized or a movement pattern or
color effect and to insert it into the chase. For this, call the scene or the effect with
the button SCENE or MOVEMENT and the corresponding number button.
8. Press the button REC to memorize the scene.
• To confirm the memory procedure, all LEDs of the controller flash three times.
• The indication "Step001" changes to "Step002" and you can adjust and memorize
the next scene.
9. Repeat the steps 6 to 8 to adjust and memorize the next scene.
• Up to 100 scenes can be programmed for a chase.
10. After the desired chase has been memorized, switch off the programming mode.
For this, keep the button ENTER pressed until the display indication switches back to
"Manual".
Inserting a Scene Into a Chase
1. Call the programming mode. For this, keep the REC pressed until the LED above
the button lights.
2. Press the button CHASE.
• The control LED lights.
3. Select the chase to be extended with one of the number buttons 1-16.
• The control LED of the number button lights and the display indicates the number
and steps of the chase.
• If necessary, use the button PAGE to switch between the two channel groups 1-16
(LED A lights) and 17-32 (LED B lights).
4. Select the step after which a new step is to be inserted with the pan wheel.
5. Press the button MENU.
• The LED INSERT above the button lights.
6. Now, a scene can be inserted. For this, call the scene with the button SCENE and
the corresponding number button.
7. Press the button REC to memorize the revised chase.
• To confirm the memory procedure, all LEDs of the controller flash three times.
8. Repeat the steps 4 to 7 to insert further scenes into this chase.
©Copyright Lotronic 2018
Program
CH:02 Val:098
Manual DMX512-PRO
15
Publicité
