Publicité
Les langues disponibles
Les langues disponibles
9. After the revised chase has been memorized, switch off the programming mode.
For this, keep the button ENTER pressed until the display indication switches back to
"Manual".
Playing a Chase
A chase must be programmed before you can call it. Chases can be played manually,
time- controlled or sound-controlled. As a basic setting, the manual mode is
activated. The LEDs MANUAL, MUSIC and AUTO indicate the current setting.
1. There should be no device or illumination scene selected. If one of the control
LEDs of the number buttons 1-16 light, press the corresponding button for
deselecting.
2. Press the button CHASE.
• The control LED lights.
Fig. 7.11 Calling a chase
3. Use the number buttons 1-16 to select the desired chase.
• The control LED flashes.
• If necessary, use the button PAGE to switch between the two channel groups 1-16
(LED A lights) and 17-32 (LED B lights).
• Up to 5 chases can be selected simultaneously. The chases are played one after the
other. The LED of the chase currently playing flashes, the others light.
• The display indicates the number of the chase (e.g. "Chase01") in the lower line and
the current step (e.g. "Step001).
4. Select the chase running mode with the button RUN MODE. The mode is indicated
by the LEDs next to the button.
Fig. 7.12 Chase in manual mode
• MANUAL: The chase can be manually advanced step by step with the pan wheel.
Fig. 7.13 Chase in sound-controlled mode
• MUSIC: The individual steps of the chase run to the rhythm of the music picked up
via the internal microphone.
The sensitivity of the sound control is adjustable. For this, keep the button RUN
MODE pressed and turn the tilt wheel to adjust a value between 0-100 %. The higher
the value, the higher the sensitivity.
©Copyright Lotronic 2018
Manual
Chase01 Step001
Manual
Chase05 Step080
Music
Sensitivity 050%
Manual DMX512-PRO
16
Publicité
